Simpson Water Blaster ALWB60828 Pressure Washer Manual

The Simpson Water Blaster ALWB60828 is a powerful pressure washer designed for efficient cleaning of various surfaces. With a maximum pressure of 2800 PSI and a flow rate of 2.3 GPM, this pressure washer is ideal for tackling tough dirt, grime, and stains on driveways, decks, and vehicles. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 2800 PSI pressure output, 2.3 GPM flow rate, 25-foot high-pressure hose, adjustable spray nozzle, and a powerful 196cc engine.

Installation

Unpack the pressure washer and inspect all components. Place the unit on a stable surface.

1. Attach the high-pressure hose to the pressure washer and the spray gun.
2. Connect the water supply hose to the water inlet.
3. Ensure all connections are secure before starting the unit.
4. Fill the fuel tank with the appropriate fuel type.

WARNING! Always follow safety precautions when handling fuel and water connections.

First-Time Setup

Before operating the pressure washer, ensure all components are properly connected.

1. Check oil levels and add oil if necessary.
2. Turn on the water supply and check for leaks.
3. Start the engine according to the manufacturer's instructions.
4. Test the spray nozzle settings before beginning cleaning tasks.

CAUTION! Ensure the area is clear of obstacles before operating the pressure washer.

Specifications

• Maximum Pressure: 2800 PSI.
• Flow Rate: 2.3 GPM.
• Engine Type: 196cc OHV engine.
• Hose Length: 25 feet high-pressure hose.
• Weight: Approximately 65 lbs.
• Fuel Type: Unleaded gasoline.
• Warranty: 2 years limited warranty.

Controls and Settings

Access controls on the pressure washer for starting and stopping the engine, adjusting the spray nozzle, and controlling the water flow.

Spray Gun: Trigger control for water flow, adjustable nozzle for spray pattern.

Engine: Start/stop switch, choke control for cold starts.

Connecting Accessories

Compatible with various cleaning accessories for enhanced functionality.

1. Turn off the pressure washer before connecting accessories.
2. Match the accessory to the spray gun and secure it properly.
3. Test the connection before starting the unit.

Tip: Use appropriate accessories for specific cleaning tasks to achieve the best results.

Operating the Pressure Washer

Follow these steps to operate the pressure washer safely and effectively.

1. Start the engine and allow it to warm up.
2. Adjust the spray nozzle to the desired setting.
3. Begin cleaning by pulling the trigger on the spray gun.
4. Move the spray gun in a sweeping motion for even cleaning.
5. Turn off the engine and release pressure after use.

WARNING! Never point the spray gun at yourself or others.

Maintenance and Care

Regular maintenance is essential for optimal performance and longevity of the pressure washer.

1. Check oil levels regularly and change oil as needed.
2. Clean the air filter and replace if necessary.
3. Inspect hoses and connections for wear or damage.
4. Store the unit in a dry place when not in use.

CAUTION! Always disconnect the spark plug before performing maintenance.

Safety Information

Read all safety instructions before operating the pressure washer. Wear appropriate protective gear, including goggles and gloves.

WARNING! High-pressure water can cause serious injury; always handle with care.

Troubleshooting

Reset: Refer to the manual for reset procedures if applicable.

Service: For assistance, contact customer support at 1-800-555-0199.